1.25" Adapters for OTI Quantum 4 Telescope

This listing is for a 3D printed adapter that will thread into the designated port of the OTI Quantum 4 telescope allowing 1.25" accessories to be used; eyepieces, barlows, diagonals, cameras, etc. The adapter is printed in strong and durable PETG Carbon Fiber. It includes a metal thumbscrew with brass compression ring to retain the accessory without damaging or marking the item.

Please message if you'd like to inquire if these fit the Q6 or larger.

Dimensions:

Overall Height: ~43

Flared Width: 42.5mm

Body Width: 36mm

1.25" Internal Depth: 35mm

Threads: Axial: 1 1/4" x 28tpi, Top: ~1 1/8" x 24 tpi

Thread depth: 4.75mm

Opening at threads: 26mm (axial), 24mm (top)

Weight: 26g

*Reminder* - This part is 3d printed and the threads on this adapter are plastic, while they are strong and accurate, it is easier to cross-thread this item and permanently damage the threads than with a metal part. Take great care when threading this on; I like to turn it counterclockwise until you feel it click into the first thread, then rotate clockwise to tighten. If you feel strong resistance, stop immediately and try it again. If it is too tight no matter what, make sure your female threads do not have any gunk, dirt, grease, dust embedded into the threads (my scope did, I was able to clean them out with a small dental tool or the appropriate thread pitch guage).